Nog geen account? Account aanmaken
Uw winkelwagen is leeg
The TPA3116 Class D amplifiers provide high-performance, thermally efficient amplifier solutions. This board delivers 100 watts of power in a small package.
This Class-D audio amplifier board gives you 2 x 100 watts using T-AMP technology. Using PBTL (Parallel Bridge-Tied Load) topology you get 50 watts RMS per channel with only 0.01% THD at 4 ohms.
This Class-D audio amplifier board simplifies the creation of exceptional sounding custom multi-channel systems. It has perfect class-T architecture and is integrated with a high performance STA508 chip supporting dual channel audio amplification.
Design your own powered subwoofer, powered speaker or audio amplifier with Sure's 2 x 500 watt stereo amp board. It's ready to handle mid power demanding audio projects.
Dayton Audio's DTA-2 amp module maakt gebruik van een Class-T Tripath audiochip die een ongelofelijke betrouwbaarheid en efficiëntie oplevert. Voeg een 12 VDC 2A externe voeding toe aan de Dayton Audio's DTA-2 amp module en de module levert bijna overal e
50cm balanced signal cable with 4-pin connectors on both sides to connect the DLCP to the NC400 module.
The Fusion Remote Kit is suitable for extending all FusionAmp models with remote compatibility.
The Hypex Remote Control is a remote controller which can be used in combination with the Fusion Amp remote kit.
The HPR12 is a 12V voltage regulator. Together with the HNR12 it forms the optional HxR upgrade for UcD180HG and Ucd400HG.
SMPS3kA400 2 x 65 VDC 3000 Watt Switch Mode Power Supply is specially designed to be used in combination with multiple UcD400HG, UcD400HG HxR or NC400 modules. This SMPS comes with the required Hypex Cable Set SMPS3k.
SMPS1200A700 2 x 85 VDC 1200 Watt Switch Mode Power Supply is specially designed to be used in combination with the UcD700HG HxR module. This SMPS comes with the required Hypex Cable Set SMPS1200.
DLCP 2x6 Digital Loudspeaker Cross-over Platform is a complete hardware/firmware platform for digitally filtered (6 channels) and corrected active multiway loudspeakers.
The FA253 2x250 +100 Watt FusionAmp is a DSP controlled three channel plate amplifier. It can be the basis of a powerful active two- or three-way speaker.
The UcD2k amplifier module is an entry level high-end class D amplifier from Hypex. The UcD2k is known for its high performance, reliability and ease of use. The UcD2k comes with the required UcD Signal Cable.
The UcD180HG HxR amplifier module is an entry level high-end class D amplifier, with HxR upgrade from Hypex. This amplifier is known for its high performance, reliability and ease of use. The UcD180HG hxR comes with the required UcD Signal Cable.
Dayton Audio's PC68-4 2-1/2" full-range driver will deliver smooth and natural response from extremely compact designs. When used in line arrays, portable speakers, sound bars, or as a dedicated midrange in 3-way designs this driver will prove to be an ex
Dayton Audio's DC130B-8 5-1/4" Classic Series midwoofer is perfect for compact 2-way designs as well as use in multiples or transmission lines.
Incorporating a low-distortion motor system with a copper ring, a copper cap, and an aluminum phase plug, the RS75-8 can outperform "boutique" drivers that cost several times the price.
5.8 cm (2.3") Full-range speaker with coated paper cone and rubber surround to achieve an IP64 rating, making this driver suitable for outdoor use.
30 cm (12") woofer with air-dried cone and pressure vented pole piece.
25 cm (10") woofer with air-dried cone and cone reinforcement. Front or rear mounting possible. Very good price/performance ratio and high power handling.
13 cm (5") woofer with robust polypropylene membrane for very compact subwoofer.
10 cm (4") woofer with low resonant frequency and compact size.
The Discovery series offer traditional design, superior sound, a solid construction, and a wide range of variants. Combining these elements - plus a wealth of technical features and finesses - gives our customers the possibility of acquiring a tailor-made
